Superelay II is the updated version of Superelay! This new version now has an output for LED Tally Lights. It will directly drive low-voltage Tally lights with up to 300ma of current.

Superelay II is a multi-circuit controller for any application where numerous circuits, including AC line voltage, need to be switched simultaneously. It is ideal for controlling On The Air tally lights and switching the various equipment functions that need to be controlled when, for example, the microphone in a broadcasting studio is turned on.

Superelay II provides six isolated SPDT relay outputs, plus AC and DC Tally Light output that can be set to flash. The AC Tally Light output can supply up to 200 watts of line voltage, and is switched with a synchronous solid-state relay to prevent electrical noise or arcing. The DC Tally Light output can supply up to 300mA at 12V DC; it can also "sink" up to 1A of currant if used with an external power source. All relay and Tally Lights outputs switch simultaneously.

Superelay II can be controlled with an external DC voltage (5-24 volts), a momentary or continuous contact closure, or any circuit that switches to ground. Control inputs and relay outputs are via plug-in Euroblock connectors. A front panel LED indicates Tally on/off status. A Slave output permits multiple Superelay II units can operate in tandem from a common Control input.

Superelay II is 1/3 rack width and can be mounted in an optional rack shelf, or wall mounted with optional wall/cabinet mounting brackets.

Technical Specifications
Control Inputs
ON: Mom. or cont. contact closure
OFF: Mom. or cont. contact closure
DC: 5-24VDC, maintained

Relays: 6 form-C (SPDT), 1A, 24V DC max.
AC Tally Light: AC Line Voltage, 200W max. DC Tally Light: 12 V DC, 300mA max/1A current sink max.

Control inputs, relay & DC outputs: euroblocks
AC Tally Light: Grounded AC receptacle
Power Input
115/230V AC, 50-60Hz, 4W + Tally load
Steel enclosure
Physical 5.7”w X 1.7”h X 6.0”d, 3lbs
Mounting Table top, optional rack mount shelf, optional wall/cabinet mounting brackets

Typical Application


Technical specifications subject to change without notice.

Henry Engineering,
PO Box 3796
Seal Beach, CA 90740
Tel: 562-493-3589


RETURN TO HOMEPAGE Copyright 2013, Henry Engineering